Showing 1–12 of 34 results

2″ Rudder Offset Arm

Use with our Uni-Strut Rudder mount, places rudder offset 2″ to the right or left from center. Can use two

3″ Offset Rudder Arm

Use for a single offset or replacement for our Dual Rudder System.

4.5″ Shaft / Ferrule

Replace prop shaft for XP-2 and XP-2C drive systems. Features ground Stainless Steel construction with solder-less 0.250″ square female connection.

5.5″ Shaft / Ferrule

Designed and manufactured by us with precision quality + or – .001 tolerance. One piece prop shaft and ferrule design

Bullet Prop Nut

Designed by Tony machined from Brass our Bullet Prop Nut will look great on your boat. A thin “Jam-Nut” is included

Cable/Shaft Assembly (SPDIII)

This kit includes (1) 1/4″ Drive Hub, (3) Thrust Washers, (1) 5.5″ Shaft/Ferrule (square), (1) 1/4″ Prop Nut and a

Cable/Shaft Assembly (XP2 / XP2-Offset)

This kit includes (1) 1/4″ Drive Hub, (3) Thrust Washers, (1) 4.5″ Shaft/Ferrule (square), (1) 1/4″ Prop Nut and a

Clutchless Adapter

Use this PTO directly to your Zenoah engine tappered crank shaft. Comes with a 6mm threaded shaft that is screwed to


Enforcer machined aluminum Trim Tabs for RC boats. 3″ tall x 1.5″ mounting brackets and hardware included.

Enforcer Rudder Pin

Used on most Enforcer drives replaces pin: Dual Rudder Assy.. XP-2, XP-2C