Drives & Parts

Display: List / Grid
Sort By:
Bullet Prop Nut
Designed by Tony machined from Brass our Bullet Prop Nut will look great on your boat. A thin "Jam-Nut" is included to secure the prop and hold the prop nut in place. ..
Clutchless Adapter
Use this PTO directly to your Zenoah engine tappered crank shaft. Comes with a 6mm threaded shaft that is screwed to the mid-point of the engine PTO tapered shaft. Using a small amount of medium thread lock on both ends screw the Cluth-less Adapter onto the threaded stub and tighten. Designed t..
Drive Dog
1/4" I.D. replacement drive hub. ..
Hydro Strut Assembly
The perfect strut and mount system for your hydro. Light weight for racing but durable for everyday sport use. Uses standard .250" L/T bearings, and can be used with our 4.5" Enforcer stub shaft/ ferrule. ..
SPD III Stinger
ENFORCER SPDIII STINGER - Includes SPDIII Stinger Body, Bracket and plate, Prop shaft cartridge with Lead Teflon Bearings pressed in and mounting hardware.  In 1983 Tony C owner of WHH introduced surface drive to the world of model boaters, though it was used on some full size offshore race ..
Thrust Washer Set (6)
Thrust washers or thrust bearings are very important in gas model boating as well as necessary for most Enforcer drive systems. With a floating, or solder-less drive cable system using square ends such as ours, the forward thrust (motion) produces a great amount of pressure that bears down on the re..
1.25" Rudder Offset Arm
3" Offset Rudder Arm
Use for a single offset or replacement for our Dual Rudder System. ..
4.5" Shaft / Ferrule
Replace prop shaft for XP-2 and XP-2C drive systems. Features ground Stainless Steel construction with solder-less 0.250" square female connection. ..
5.5" Shaft / Ferrule
Designed and manufactured by us with precision quality + or - .001 tollerance. One piece prop shaft and ferrule design enable connection without solder or adhesives. Requires a 1/4" square end drive cable to couple to the 1/4" square female ferule end. ..
Enforcer Rudder Pin
Used on most Enforcer drives replaces pin: Dual Rudder Assy.. XP-2, XP-2C ..
Enforcer Rudder Pivot Block
Use with our large 6" machined rudder. Replacement: Dual Rudder Assy., XP-2, XP-2C Drives. ..
Lead Teflon Bearings
Lead Teflon Bearing - PAIR. Used in Enforcer, Bonzi, Speedmaster, Octura and other drives...
Prop Nuts (2 Pack)
Set of two thin lock nuts for use with all of our prop shafts and most other manufacturers using industry standard 1/4" X 28 threads. Stainless Steel construction. ..
Prop Shaft Cartridge
Supports Prop Shaft. Precision machined to fit into SPD III Stinger body. Includes lead teflon bearings. ..
Powered By OpenCart
ENFORCER RC Boats © 2018