Drives & Parts

Display: List / Grid
Show:
Sort By:
Bullet Prop Nut
Designed by Tony machined from Brass our Bullet Prop Nut will look great on your boat. A thin "Jam-Nut" is included to secure the prop and hold the prop nut in place. ..
$4.95
Clutch-Less Adapter
Use this PTO directly to your Zenoah engine tappered crank shaft. Comes with a 6mm threaded shaft that is screwed to the mid-point of the engine PTO tapered shaft. Using a small amount of medium thread lock on both ends screw the Cluth-less Adapter onto the threaded stub and tighten. Designed t..
$14.95
Drive Dog
1/4" I.D. replacement drive hub. ..
$4.95
Hydro Strut Assembly
The perfect strut and mount system for your hydro. Light weight for racing but durable for everyday sport use. Uses standard .250" L/T bearings, and can be used with our 4.5" Enforcer stub shaft/ ferrule. ..
$34.95
SPD III Stinger
ENFORCER SPDIII STINGER - Includes SPDIII Stinger Body, Bracket and plate, Prop shaft cartridge with Lead Teflon Bearings pressed in and mounting hardware.  In 1983 Tony C owner of WHH introduced surface drive to the world of model boaters, though it was used on some full size offshore race ..
$44.95
Thrust Washer Set (6)
Thrust washers or thrust bearings are very important in gas model boating as well as necessary for most Enforcer drive systems. With a floating, or solder-less drive cable system using square ends such as ours, the forward thrust (motion) produces a great amount of pressure that bears down on the re..
$2.95
1.25" Rudder Offset Arm
..
$8.95
3" Offset Rudder Arm
Use for a single offset or replacement for our Dual Rudder System. ..
$9.95
Enforcer Rudder Pin
Used on most Enforcer drives replaces pin: Dual Rudder Assy.. XP-2, XP-2C ..
$5.95
ENFORCER Rudder Pivot Block
Use with our large 6" machined rudder. Replacement: Dual Rudder Assy., XP-2, XP-2C Drives. ..
$12.95
Lead Teflon Bearings
Lead Teflon Bearing - PAIR. Used in Enforcer, Bonzi, Speedmaster, Octura and other drives...
$5.95
Lead Teflon Bearings
Lead Teflon Bearing - PAIR. Used in Enforcer, Bonzi, Speedmaster, Octura and other drives...
$5.95
Prop Nut
Set of two thin lock nuts for use with all of our prop shafts and most other manufacturers using industry standard 1/4" X 28 threads. Stainless Steel construction...
$1.25
Prop Shaft Cartridge
Supports Prop Shaft. Precision machined to fit into SPD III Stinger body. Includes lead teflon bearings. ..
$14.95
Package of (2) nylon rudder pin bushings for use all most Enforcer rudder systems, ..
$4.95
Powered By OpenCart
ENFORCER RC Boats © 2017